Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Fast, Reliable Garage Door Cable Repair Across Sunset
A snapped garage door cable in Sunset usually means one thing: your door is stuck, half-open, with the full weight sitting on whatever’s left. Most cable repairs in Sunset run $130 – $250, and our techs carry the common cable sizes, drums, and stainless bottom brackets on the truck so most jobs are done in a single visit. If you’re hearing grinding from the tracks or the door is cocked at an angle, call (254) 602-5116 and a live person answers, day or night.
Sunset’s salt-laden coastal air attacks garage door hardware faster than almost any other environment in Florida. The cables, brackets, and drums on a one-story CBS ranch here corrode from the inside out, often failing without much visible warning. We’re familiar with every block between Sunset Drive and the older 1950s subdivisions, and we know what fails first.
Why Brock Garage Door Repair Is Sunset’s Preferred Garage Door Cable Repair Company
Our reputation in Sunset comes down to two things: we hand you a written price before a single bolt turns, and every repair is covered by our 365-Day Done Right Promise. If the fix fails within a year, a uniformed, background-checked technician returns at no charge. No negotiations, no “we’ll see what we can do.” It’s in writing.
Response time to Sunset matters when your door is hanging by one cable and the opener is straining against a crooked panel. We dispatch crews from our South FL office straight into the neighborhood, and because we stock Chamberlain, Genie, and Clopay cable-and-drum components locally, we’re not waiting on a parts shipment while your garage sits open. The tech who arrives is the same one who prices the job and does the work.
Wade Mercer, who runs our operation, set the standard early: show up in the window, price it in writing, do it by the book, leave it clean. Sunset homeowners who’ve been burned by no-show contractors tend to notice the difference.
Garage Door Track Repair in Sunset
Garage Door Track Repair in Sunset is a job we handle almost weekly, usually because salt air has attacked the steel track brackets or because a snapped cable yanked the track out of alignment before the owner could stop the door. When a cable lets go mid-travel, the panel lurches sideways and bends the vertical track or pulls the fasteners out of the concrete block. Repairs run $120 – $240 depending on whether we’re realigning, re-securing, or replacing a section of track.
Realignment and re-securing
We re-tighten the track to the door opening, set the correct gap between the rollers and the track flange, and check the side-to-side level along the full travel. On Sunset’s older CBS homes the track mounts are often anchored into block with fasteners that have rusted from rain splash and humidity. We swap them for coated hardware when we see pitting.
Bent or crushed sections
A door that comes down on a snapped cable can bend the vertical or horizontal track enough that rollers bind and the opener pulls against itself. We replace the damaged section, re-slope a horizontal track if needed, and re-set the end bearing plates so the whole assembly runs clean.
Garage Door Hinge Replacement in Sunset
Garage Door Hinge Replacement in Sunset is most common on the original 1950s and 1960s sectional doors still running on many one-story CBS homes. The bottom hinges take the most shear load and sit closest to the slab, where salt-laden air and storm-driven rain collect. When those hinges seize or crack, the panel stops folding properly and the cable on that side takes uneven tension. Replacement runs $110 – $220 depending on count and panel type.
Seized and cracked hinges
We see hinges that have rusted solid, forcing the panel to flex against the roller stem until the stem snaps or the hinge plate cracks at the screw line. Our techs replace them with galvanized hinges and re-check alignment so the door doesn’t fight itself on the way up.
Hinges after a cable failure
When a cable snaps and the door hangs crooked, the hinge line twists under load. Even if the hinge looks fine from the outside, the internal pin often bends. We inspect every hinge in line with the failed cable and replace the stressed ones so you don’t get a second failure three weeks later.
Trusted Brands We Service in Sunset
Our Garage Door Cable Repair techs are trained on the systems Sunset homeowners actually run: Chamberlain, Genie, Clopay, and Amarr. We stock replacement cables, drums, bottom brackets, and end bearing plates sized for each brand so there’s no generic parts shuffle. Whether it’s an original Clopay steel sectional from the 1980s or a newer Miami-Dade NOA wind-rated Amarr door, the right part goes on the first time.
Common Garage Door Cable Repair Problems We See in Sunset Homes
- Corroded bottom brackets and end bearing plates. On original 1950s – 1980s CBS garages, the mild-steel bottom brackets pit from salt air within a few seasons. When we trace a lifted or snapped cable back, we usually find the anchor has corroded as badly as the cable itself.
- Cables failing after a door upgrade. When a Sunset homeowner upgrades to a Miami-Dade NOA wind-rated door, the panel is heavier. The existing torsion spring and anchor are often undersized, and the added load stresses the drum and end bearing plates until the cable strands part.
- Frayed cables without visible warning. Original cables on older Sunset doors corrode from the inside where they wrap the drum. They look fine on the outside, then part mid-travel during the pre-June 1 hurricane-season check.
- Doors cocked at an angle after a snap. A single-side cable failure leaves the sectional door hanging crooked in its tracks. Forcing the opener to move it bends hinges, further damages the track, and strains the spring assembly.
Pricing for Garage Door Cable Repair in Sunset, FL
A typical cable repair in Sunset runs $130 – $250. Track realignment adds $120 – $240 when the snap pulled the track out of line. A full door repair, which can include cables, hinges, and roller work, runs $150 – $600. Coastal corrosion does push some Sunset jobs toward the higher end, because we’re replacing rusted bottom brackets and end bearing plates instead of just restringing a cable. You get a written price before work starts, and the number on the invoice matches the number you approved.
| Service | Sunset Price Range |
|---|---|
| Cable Repair | $130 – $250 |
| Track Realignment | $120 – $240 |
| Garage Door Repair | $150 – $600 |
Estimates are free. Call (254) 602-5116 and we’ll give you an exact figure before any work begins.
We Also Serve Cities Near Sunset
Brock Garage Door Repair serves Garage Door Cable Repair in Sunset and the surrounding South FL region. We regularly send crews to Jacksonville, Miami, Tampa, and Orlando. If you’re outside Sunset proper, call and we’ll confirm dispatch coverage for your area.
Serving Sunset, FL - Our Local Coverage Area
We’re based in the Sunset area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Garage Door Cable Repair in Sunset
Salt-laden air from the coast pits the bare steel hardware on older Sunset doors, especially the bottom brackets and end bearing plates on 1950s – 1980s CBS construction. The cable itself corrodes from the inside where it wraps the drum, so it fails without much visible warning. Most cable failures in Sunset trace back to corroded anchors, not just the cable wearing out on its own. Call (254) 602-5116 for an inspection before hurricane season.
We don’t recommend it. A door with one snapped cable is carrying uneven load, and lifting it by hand can stress the remaining cable, the hinges, and the spring. If you must open it, pull the emergency release and lift straight with help, but the safer call is to wait for our tech. We answer live 24/7, including Saturdays, and we’ll get a uniformed technician out to Sunset the same day in most cases.
Usually yes. Miami-Dade NOA wind-rated doors weigh more than the original wood or light steel panels they replace. The existing torsion spring and anchor are often undersized for the heavier panel, and the added load stresses the cables, drums, and end bearing plates. We re-engineer the spring and cable assembly as part of any wind-rated door replacement in Sunset, not after the cables have already parted under load.
Cable repair in Sunset runs $130 – $250. Salt air does push some jobs toward the upper end because we often replace the bottom brackets, end bearing plates, and drum at the same time rather than just restringing a cable. Inland jobs rarely need that anchor work. You get the exact written price before we start. Call (254) 602-5116 for a quote based on your door.
Look at the door. A snapped cable usually leaves the door cocked at an angle, with one side higher than the other and a dangling or frayed steel cable visible near the drum. A broken spring makes a loud bang and the door won’t lift at all, even with the opener running. If you’re not sure, don’t force the opener. Our techs diagnose it in minutes and tell you exactly what needs replacing. Call (254) 602-5116 and we’ll talk you through what you’re seeing.
Need a cable repair in Sunset? Call (254) 602-5116 for a free estimate. A live person answers around the clock, and every job gets a written price and a 365-day written guarantee. The fix is done right, or we come back at no charge.
Written by Wade Mercer, Owner at Brock Garage Door Repair, serving Sunset, FL.






Before
After
Before
After
Before
After